WARNING
!
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
Disassembly Procedures
18
16022880 Rev. 0
©2004 Maytag Services
Oven Thermostat
1. Disconnect power and shut off gas supply to unit.
2. Remove control panel, see “Control Panel” procedure.
3. Remove maintop, see “Maintop” procedure.
4. Remove screws securing sensing bulb to bracket,
located inside the oven cavity.
5. Gently pull sensing bulb out through the oven cavity.
NOTE:
Take care not to disturb the insulation.
6. Remove screws securing selector switch to bracket.
7. Remove screws securing bracket.
8. Remove screws securing thermostat to bracket.
9. Disconnect and label wire terminals from thermostat.
10. Reverse procedure to reassemble.
Single Feed Burner
1. Disconnect power and shut off gas supply to unit.
2. Removing the corresponding grate, burner cap and
port ring.
3. Remove venturi bolt securing burner base.
4. Burner base can now be lifted off maintop.
5. Disconnect electrode wire from burner base.
6. Reverse procedure to reassemble.
NOTE:
When repairing or replacing burner jet or burner
tubing, maintop must be removed.
Dual Feed Burner Base
NOTE:
Maintop needs to be removed for burner base
replacement.
1. Disconnect power and shut off gas supply to unit.
2. Remove maintop, see “Maintop” procedure.
3. Remove gas lines from burner base.
4. Remove screw securing ground wire, located at the
front of the burner hanger.
5. Remove screw securing front baffle to burner hanger.
6. Trace high voltage electrode wire to spark module and
disconnect.
7. Pull electrode wire through front baffle.
8. Remove dual feed burner base off of hanger, by
removing screws from the bottom of the hanger.
9. Reverse procedure to reassemble.
Light Socket
1. Disconnect power supply to unit.
2. Open the oven door.
3. Unscrew oven light cover, located inside oven cavity.
4. Unscrew light bulb and remove.
5. Gently pry the three locking tabs inward towards
center of socket.
6. Once locking tabs are released, remove light socket
from oven cavity.
7. Disconnect wire terminals connections and transfer
wire terminal connections to new light socket.
8. Reverse procedure to reassemble.
Control Box
1. Disconnect power supply to unit.
2. Remove screws securing kick plate at each top
corner.
3. Remove screws securing control box to unit chassis.
4. Carefully slide control box out, to gain access to
relays.
NOTE:
On replacement of any components in the
control box, verify proper wire location.
5. Reverse procedure to reassemble.
High Temperature Cutout
NOTE:
High Temperature Cutout is located in the center
of the unit, underside of the oven cavity.
1. Reset the switch when needed by pressing in button
on bottom of switch.
2. Switch can be replaced, by removing screws,
detaching wires, and replacing.
Selector Switch
1. Remove control panel, see “Control Panel” procedure.
2. Remove screws securing landing ledge on each side
of landing ledge.
3. Unscrew selector switch from the bracket.
4. Remove screws securing top of bracket.
5. Disconnect and label wire terminals to selector switch.
6. Reverse procedure to reassemble.
