12
INSTALLATION INSTRUCTIONS
Unpack Grill
Excessive Weight Hazard
Use two or more people to move and install grill.
WARNING
Failure to do so can result in back or other injury.
Unpack Grill
1.
Remove all packaging materials and remove grill from the shipping
base.
2.
Move grill close to desired outdoor location.
3.
Open the grill hood.
4.
Using an utility knife to cut yellow straps and packing tape to open
box from top and remove the boxes.
5.
Remove the warming shelf and grill grates from inside the grill and
remove the package inside the firebox.
6.
Remove foam block and wrap from inside the grill.
7.
Replace the grill grates.
8.
Place warming shelf on brackets as shown.
A
B
A
A. Warming shelf brackets
B. Warming shelf
9.
Dispose of/recycle all packaging material.
Install 20 lb LP Gas Fuel Tank Tray
The tank tray should be secured to a fixed location that can be easily
accessed and will allow the gas pressure regulator/ hose assembly to
connect to the 20 lb LP gas fuel tank without kinking or putting strain on
the gas pressure regulator/ hose assembly.
1.
Place the tank tray in a location that can be secured using
4 screws (supplied) through the predrilled holes.
2.
Use 4 screws to secure the tank tray. The typical location for a 20 lb
LP gas fuel tank is within the enclosure where the tank ban be turned
on and off easily.
A
A. Four
5/32
" x 10 mm truss head screws
Install Grill
Place grill into outdoor enclosure, but leave enough room in the back to
connect to the gas supply.
LP Gas Installation
1.
Check that the LP gas pressure regulator/hose assembly is
positioned under the grill (as shown in the following illustration)
and is not pinched or kinked.
2.
Use 4 screws and the 2-piece 90° clamp mounting bracket provided
to attach the 90° brass connector to the back of the enclosure. The
brass connector is located between the flexible gas hose and the LP
gas pressure/hose assembly.
B
A
A. 4 screws
B. 2 piece 90° clamp mounting bracket
Summary of Contents for 740-0711
Page 10: ...10 REPLACEMENT PARTS 34b...
