Jenn-Air 720-0709, Installation Instructions Manual

Page: 20 / 108

20
5. Guide the lit match under the grill grate.
6. Push in and turn the burner knob to IGNITE/HI or IGNITE/ON
for the burner closest to the lit match. The burner will light
immediately. When burner is lit, turn knob to desired setting.
7. Repeat steps 3 through 6 for each main burner.
8. Remove match and replace manual lighting extension on the
right side panel.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to light them manually,
contact the Customer Service Center. See the “Assistance”
section.
Hood Lights
The grill must be plugged in for the hood lights to work. See
“Plug in Grill” in the “Freestanding Outdoor Grill Installation”
section.
To Use:
Press the LIGHTS button on the control panel to turn the hood
lights on and off.
Using Your Searing Side Burner
Infrared grilling produces intense heat which quickly sears the
meat. Searing locks in flavor and juices while allowing the outer
surface to absorb smoke and food aroma that is produced as
grease and drippings are vaporized by the burner. The result is a
crisp, flavorful outside with a tender, juicy inside.
■
Preheat the infrared sear burner for 5 minutes.
■
Ensure that meats are fully thawed and that all excess fat is
trimmed away prior to grilling.
■
Leave the burner set to HI when placing food on the grill to
sear.
■
Use the sear burner to sear meat 1 to 2 minutes on each side,
then move the meat to the main grill cooking surface to finish
grilling to the desired doneness.
IMPORTANT: It is recommended that the sear side burner lid
be raised when the burner is in use to eliminate the possibility
of increased lid and handle temperatures.
■
To close the searing side burner lid, first lift up the lid to
release the lock then lower it to the closed position.
Lighting the Searing Side Burner
1. Remove the searing side burner cover. Do not light burners
with the cover on.
2. Do not lean over the grill.
3. Push in and turn the control knob to IGNITE/ON and hold in.
You will hear the “snapping” sound of the spark. When burner
is lit, release the knob. Turn knob to desired setting.
IMPORTANT: If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.
OF
F
/O
N
Rea
Burner r
1
2
OF
F
/O
N
Rea
Burner
r