BM-16
BM-
16 Operator’s Manual
11
3.5. Usage
Plug the power cord into power socket and place the machine on the left side of the
working material in the manner shown in Figure 6. The milling head must not touch
the working edge. The working material must be stable and well fixed.
Figure 6.
Machine placed on plate and proper feed direction
To start the motor, press the switch lock and the ON/OFF switch, and, with the
ON/OFF switch pressed, release the lock. Wait several seconds until the machine
reaches the required rotational speed, press the machine to the working surface
using both hands, and slowly slide toward the edge until the tool starts to cut the
steel. Operate according to the counter-rotation, by sliding the machine from left to
right.
T
he direction of the milling head rotation is indicated by the arrow on the guide.
Begin with accomplishing small bevels (3
–4 mm, 0.12–0.16’’) and increase the
bevel width with gaining experience. It is recommended to bevel in at least two or
three passes. The bevel width should be set to a value which will allow for the feed of
1 meter per minute without significant effort.
If the machine becomes overloaded, e.g. when the bevel width is too large for the
material being machined or when the cutting inserts are blunt, the motor will
automatically stop. However, prevent the motor from overloading by machining hard
materials in multiple passes and replacing the inserts before they
become blunt.
Additionally,
take periodic breaks during operation and keep the ventilation slots
clean to prevent the motor from overheating because this can lead to damage of the
windings.
Once the work is finished, turn off the motor by releasing the ON/OFF switch, wait
until the rotation stops, and unplug the power cord from power socket.
feed direction
switch lock
ON/OFF switch
