MAGBEAST HM200T
8 |
P a g e
cutter breakage cutter
thoroughly and replace
Incorrectly re-sharpened
or worn cutter
Always have a new cutter on
hand to refer to for correct tooth
geometry,
together
with
instruction sheet
Cutter skipping
See causes and remedies (2)
Slide-ways
need
adjustment
Tighten slide-way
Cutter
not
attached
tightly to arbor
Retighten
Insufficient use of cutting
oil or unsuitable type of
oil
Fill arbor with an oil of light
viscosity and check to be sure oil
is being metered into cutter when
pilot is depressed. If not,
check pilot groove and arbor
internally for dirt or apply oil
externally.
Even a small amount of oil is very
effective.
Incorrect speed selection. Select appropriate speed.
5) ) Excessive
cutter wear
Incorrectly re-sharpened
cutter.
Refer to instructions and a new
cutter for proper tooth geometry
Insufficient or spasmodic
cutting pressure
Use sufficient steady pressure to
slow the drill down. This will
result in optimum cutting speed
and chip load.
