17
USER MANUAL
JEFMIG151-A
151A MIG WELDER - 230V
~
50Hz
www.jeffersontools.com
14.6.5 Disconnect the black liner from the torch control assembly by
pressing the locking ring into the connector and withdrawing the
liner. See A in fig.19.
14.6.6 With the torch cable as straight as possible pull the liner from the
torch cable.
14.6.7 Insert the new liner into the torch cable and secure it in the wire
drive unit by replacing the torch cable clamp. See fig.17. Insert
the other end of the liner through the locking ring and fully into the
torch control assembly.
14.6.8 Ensure that the switch moulding (fig.19-3) is fully seated down
into the lower moulding (4). Place the torch head assembly (2)
down into the lower moulding and arrange the inner connections
within the moulding. The gas pipe and wire liner will rest into
notches on the inner ribs of the moulding.
The two thin switch wires should be to the left
of the gas pipe and the larger black control
cable should be to the right of the wire liner.
14.6.9 Hook the upper moulding (1) onto the lower
moulding (4) as shown in fig.18-7. Close
the upper moulding down onto the lower
moulding ensuring that there are no wires
trapped between the two halves. The two
mouldings should close easily, do not force
them shut.
14.6.10 Once the mouldings are closed slide the
locking ring (fig.18-5) up onto them. Turn
the locking ring clockwise to secure the
assembly.
FIG. 17
Parts & Servicing
For Jefferson approved replacement parts contact your
nearest dealer or contact Jefferson tools
Telephone:
+44 (0)1244 646 048
Fax:
+44 (0)1244 241 191
Email:
FIG. 18
FIG. 19
