8. If the child restraint has a top tether strap and the
seating position has a top tether anchorage, con-
nect the tether strap to the anchorage and tighten
the tether strap. See
page 278 for directions to
attach a tether anchor.
9. Test that the child restraint is installed tightly by
pulling back and forth on the child seat at the belt
path. It should not move more than 1 inch
(25.4 mm) in any direction.
Any seat belt system will loosen with time, so check the
belt occasionally, and pull it tight if necessary.
Installing Child Restraints Using The Top
Tether Anchorage
WARNING!
Do not attach a tether strap for a rear-facing car seat
to any location in front of the car seat, including the
seat frame or a tether anchorage. Only attach the
tether strap of a rear-facing car seat to the tether
anchorage that is approved for that seating position,
located behind the top of the vehicle seat. See
page 274 for the location of approved tether
anchorages in your vehicle.
The Top Tether anchorages are located behind each
rear seating position. To attach the tether strap of the
child restraint:
1. Place the child restraint on the seat and adjust the
tether strap so that it will reach over the seat back,
under the head restraint and to the tether anchor
directly behind the seat.
2. Release the seat back by pulling the release strap
located on the top of the seat back to provide room
to reach the tether anchor.
3. Route the tether strap to provide the most direct
path between the anchorage and the child seat. The
tether strap should go between the head restraint
posts underneath the head restraint. You may need
to adjust the head restraint (if adjustable) to the
upward position to pass the tether strap underneath
the head restraint and between its posts.
4. Attach the hook to the wire anchorage on the cab
back wall (inside the opening labeled with the tether
anchorage symbol.)
5. Push the seat back rearward until the latch engages
and no red indicator is showing on the strap.
6. Tighten the tether strap according to the child seat
manufacturer's instructions.
WARNING!
•
An incorrectly anchored tether strap could lead to
increased head motion and possible injury to the
child. Use only the anchorage position directly
behind the child seat to secure a child restraint top
tether strap.
•
If your vehicle is equipped with a split rear seat,
make sure the tether strap does not slip into the
opening between the seatbacks as you remove
slack in the strap.
SAFETY TIPS
TRANSPORTING PASSENGERS
NEVER TRANSPORT PASSENGERS IN THE CARGO AREA.
WARNING!
•
Do not leave children or animals inside parked
vehicles in hot weather. Interior heat buildup may
cause serious injury or death.
•
It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision, people
riding in these areas are more likely to be seriously
injured or killed.
•
Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts.
•
Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
Tether Anchorage Locations
SAFETY
279
6
Summary of Contents for GLADIATOR 2022
