color coding and are indistinguishable
from each other by electrical testing�
The tester will display the “PASS” icon
when all 8 pins are correctly wired in
a one-to-one order� If all 8 pins are
correctly wired with the 1-2 and 3-6
pairs crossed, a wire map displaying
the cross-over wires, a “PASS” icon and
the X-OVR message will be displayed.
Uplink cables (a�k�a� crossover or
T568A-to-T568B cables) are commonly
used to connect two computers or two
hub/switches directly together�
Map ID
– The Map ID function identifies
multiple Telco, Coax or Network cables
by displaying ID numbers of the map-
only remotes attached to the far end of
the cables� It is a cost effective way to
identify up to 20 cable runs at a time�
The map-only remote are available in
F-connector plug (Coax), RJ45 plug
(Network) and RJ11 plug (Telephone)�
If there is voltage present in the cable,
the “Voltage!” warning message will be
displayed and a warning beep will be
sounded repeatedly until the voltage is
removed. Disconnect the TestifierPRO
f
from the live line and remove voltage
source from the cable before further
testing� If no failures are detected, the
PASS icon and the remote Map ID
number will be displayed� If the wrong