20
for accurate split pair indication, no more
than 10% of the total run length�
To Map Cable ID’s
1) Turn on the unit by pressing the
mode button for the type of cable
being tested (i�e� the Telco, Coax, or
Network button�) If not already in Map
ID mode, press the corresponding
mode button repeatedly until Map is
displayed and then press the SEL
button�
2) Connect the cable to be mapped to
the main unit� Insert a map-only
remote to the jack at the far end of
the cable�
3) A PASS icon and the ID number for
the map-only ID will be displayed�
The type of cable (Telco, Coax, or
Network) being tested is indicated at
the lower left corner of the screen�
A FAIL icon along with an error
message (OPEN or SHORT) will be
displayed if there is an open or short
in the cable�
To Place Tone on a Cable
1) Press the mode button (Telco, Coax,
or Network) for the type of cable
being tested� If not already in Tone
test, press the corresponding mode
button repeatedly until the Tone
