5
11
Now press the
left arrow
to go back to the
summary page. Check that the summary page
remains green. Select the
Action
button and
select
Insert Single FCS Error
.
12
Check that the screen has turned red and a
single error has appeared on the screen.
13
Quick test is now complete. Please proceed to the next section RFC 2544 testing.
4 RFC 2544 Testing Using the HST-3000
This section describes how to validate the link between two locations. The output of this test is a
go or no go on the quality of the link and the results can be saved for further analysis. This
section is expected to take approximately 20 minutes for testing.
Step
Directions
1
This section continues from 4.3. If you have not
completed that section, please do so at this time.
If you are ready to proceed, press the
action
key
and select
Stop traffic
.
2
Press the
configure
button. Tap the left and
right arrows until you get to the
Summary
Settings
Screen. Then select
RFC 2544 Mode
and press
Symmetric
.
