JCM TAIKO, Service Manual

Page: 71 / 104

4-9
TAIKO Service Manual
CHAPTER
4
© 2006 Japan Cash Machine Co.Ltd. All rights reserved.
4-3-2. Adjustment Procedure
1. Confirm the power is not supplied to the TAIKO Unit and remove the TAIKO Unit
from the faceplate. For details about removing the faceplate, refer to the 3-1. Install-
ing/Removing.
2. Connect the tool (the TAIKO Unit and the Power Supply Unit) and the harness as the
following illustration indicates.
3. Set the TAIKO’s DIP switch No.1, 2 and 8 ON. The DIP switch is located on the right
side of the unit.
4. Turn on the power to the TAIKO Unit. Confirm that TAIKO’s white LED lamp is
flashing.
5. Set the DIP switch No.1 OFF and confirm that TAIKO’s green LED lamp lights.
6. Insert the reference paper (KS-070) to the TAIKO Unit. Then the roller start rotating
and then continue to insert the reference paper all the way in.
Reference Paper (KS-070)
A1:JCM Power Supply Unit
(Part#:VM-30, EDP#:116125)
or
equivalent
TAIKO Unit
AC Power
A2:TAIKO Harness A
(Part#:3280-05-54,EDP#:127527)
Interface
Connector
Interface
Connector(10Pin)
Host Machine
ID-003/ccTalk/HII
Connector
ID-001
AC Power
B1:JCM Power Supply Unit
(Part#:VM-450, EDP#:059307)
or
equivalent
B2:VM-450 Connection Harness
(Part#:3280-05-102,EDP#:N/A)
ID-003/MDB/Pulse/ccTalk
ID-001
Connector
Interface
Connector
Without JCM Power Supply Unit
or
equivalent
C1: JCM MIB 232
(EDP #G00176)
C2 Harness MIB232
EDP#G00182-ID-0E3
EDP#G00183-ID-003