1248099_Rev1.0
RSEC3
Page
3/4
System programming
After memorizing of the desired transmitter, perform the programming of the control panel with the security element memorized. See
programming
section on control panel user’s manual.
Note: If you change the position of transmitter RS3, you must perform the system programming again, otherwise RS3 will indicate a
safety error, and the door will not work properly.
Maintenance
Table of message/error indication beeps and leds
LEDs perform a flash every 5 seconds, indicating that the equipment has a good power supply.
System Check (Check function)
Press the receiver’s CHECK button for at least 1 second to enter check mode. The indicator light will come on and four beeps will be
heard.
Perform a complete door opening and closing manoeuvre. During the system check a beep will be heard every 1,5 seconds.
To exit Check mode, press the CHECK button or wait 5 minutes. On exiting check mode, seven consecutive beeps will be heard and
the indicator light will flash continuously.
If the communication fails:
-
In case you work with RB3, halt the door manoeuvre and press the safety edges installed to detect what has failed.
-
In case you work with RS3, halt the door manoeuvre and check in operating mode (outside the Check function) that the D”
green led indicates a coverage failure too.
Perform another system check until the result is correct.
Press the safety edges
Nº flashes
check led
Signal
coverage
Result of check
Solution
Three consecutive beeps are heard
1
Very weak
Safety edge
failure Change the orientation of the transmitting-
receiving aerials or install an AED-868 or FLAT-
868 outdoor aerial to ensure the desired range.
2
Weak
OK
The
battery
consumption will be higher
A single beep is heard
3
Normal
OK
A single beep is heard
4
Good
OK
A single beep is heard
5
Very good
OK
Equipment
D1/D2 Leds
Check Led
Beeps
Message / error
Solution
RSEC3 OFF OFF 4
beeps
every 20
seconds
Indicates RS3 transmitter low battery
when trying to begin a manoeuvre
Verify the batteries of the transmitter
RSEC3 OFF OFF 4
beeps
every 20
seconds
Communication failure between
RSEC3 and RS3 transmitter when
trying to begin a manoeuvre
Verify the radio signal with the Check
function.
RSEC3 ---
---
14
continuous
beeps
You are trying to store an RS3 and
already has a RB3 stored, or vice
versa.
Reset receiver's memory and store the
desired device.
RSEC/R in
Check mode
OFF Led
flashing
according
coverage
table
1 beeps
every 5
seconds
Communication via radio OK between
RSEC3 and RB3 transmitter
---
RSEC/R in
Check mode
OFF
3
beeps
every 5
seconds
Communication failure between
RSEC3 and RB3 transmitter
Verify the radio signal with the Check
function.
VERSUS
Control panel
Led ERR ON
No beeps
Any error
Use VERSUS-PROG to know the number
of error
VERSUS
Control panel
Leds INX ON
No beeps
INX Input connection error
Connect correctly or program the safety
transmitter into the receiver
VERSUS
Control panel
Leds INX ON
---
Safety input activated
VERSUS
Control panel
Leds INX
flashing
---
Closing or opening with safety activated
