JCM Technologies INTERFACE RF, Manual

Page: 2 / 24

+ 12V dc supply 1 Magnetic detector contact channels 1 and 3
- 12V dc supply 2 Magnetic detector contact channels 2 and 4
S Decoded signal output (C4+ / Clock / D0 Wiegand) 3 Contact common
D Decoded signal output (Data / D1 Wiegand)
Introduction -------------------------------------------------------------------------- EN
Wiegand interface compatible with DCS range transmitters. Decodes in four different protocols according to its configuration:
C4+, Clock&Data, Wiegand 26 and Wiegand 37.
Technical Data
Power supply 12V dc
Frequency 433.92MHz
Consumption 12.6mA
Sensitivity Better than –100dBm
Antenna Incorporated, adjustable
Operating temperature -20ºC / +85ºC
Watertightness IP54
Dimensions 127x70x52mm
Weight 143g
Installation
Disconnect the power supply before handing the installation in the receiver.
Fitting the casing
The receiver is made up of 4 different parts: a rear cover, a circuit, a curved front cover and an adjustable aerial.
• Secure the circuit to the rear cover.
• Insert the wiring through the holes made for this purpose on the rear cover.
• Fit the rear casing cover to the wall using the rawlplugs and screws supplied.
• Slide the front of the receiver along the guide on the rear cover.
• Screw the aerial into the top of the casing.
Operating
Configuration and connection for the different protocols
Protocol
Power
supply
Signal outlet SW1 PROTOCOL SW2 PROTOCOL Format
C4+ + - S OFF OFF ---
Clock&Data + - S=CLOCK and D=DATA OFF ON 8 BCD digits
Wiegand 26 + - S=D0 and D=D1 ON OFF 8 fix bits + 16 code bits
Wiegand 37 + - S=D0 and D=D1 ON ON ---
jcm technologies
2