GENERAL CHECKS
After correct installation of the unit and the wiring, the generating set must be fully checked
over before first starting can be attempted. Points to check include:
•
Make sure that the battery isolator is at 'off' position before carrying out any checks.
•
Check all belts, guards and panel covers are firmly secured.
•
Check the installed wiring to ensure all connections are firmly installed in the correct
position, and that wires are in good condition.
•
Make sure that the battery connections are secure and polarity of connections are correct.
•
Ensure that there is fuel in the fuel tank.
•
Ensure that there is DEF in the DEF tank
•
If the machine has not been run previously, if it has run out of fuel or if the fuel supply has
been reconnected then the fuel system must be primed prior to starting. Check for fuel
leaks during this process.
•
Check level of coolant in machine radiator, and top-up if low.
•
Check hoses for damage or loose clamps.
•
Check level of engine oil using dipstick.
•
Check fuel filter/water separator for presence of water or contaminants.
•
Check the position of the 3-way valve to correct fuel source. Do not run the generator
with the 3-way valve set to the 'off' position (if applicable).
•
Visually inspect the engine and alternator for any signs of damage, water, oil or fuel leaks.
•
Make sure that all supplied documents are kept in the document holder case.
•
Ensure that machine intake and outlet air vents and grills are not obstructed or blocked in
any way to allow good airflow through the machine.
•
Check that the engine intake air filter is correctly fitted, and that there are no obstructions
to the incoming air.
•
Make sure that the that the alternator windings and assembly are not damp, or dirty.
Failure to do so could result in damage to the alternator windings. If windings are observed
to be damp/dirty contact your JCB Dealer.
•
Make sure that all the engine access doors are closed and secured.
•
With the exception of emergency power generators, the engine should be warmed up with
a reduced load before applying the full load.
11
Please consult your manual for full information or consult your local dealer
Before Starting the Engine