BATTERY ISOLATOR
The battery isolator switch is used to disconnect the battery from the machine electrics. The switch
must be turned to the off position if any maintenance work is to be performed on the machine.
Some machine systems perform shut down cycles after the engine stops. Wait until shut down cycles are
complete before setting the battery isolator switch to the off position.
At the end of a working cycle or if the machine is being left unattended and the lights are not required,
the battery must be isolated.
Disconnect
If the machine has an electronically controlled engine, you must wait a period of time before you isolate
the battery. This is to allow the ECM (Engine Control Module) to shutdown correctly. The time period
starts when you turn the ignition off. Check the isolator switch label and the operators manual for the
correct time period.
In the event of an emergency, remove the isolator key without waiting.
1. Wait for the specified duration after the engine is turned off before you isolate the battery (30 s).
2. Make the machine safe.
3. Turn the ignition to the off position.
4. Wait for the engine ECM to shutdown correctly (if installed).
5. Get access to the isolator key.
6. Turn the battery isolator key in the indicated direction and remove.
Connect
Before you start the engine or use the machine electrics, the battery isolator key must be installed and
switched on.
1. Make sure the ignition is set to off.
2. Insert the battery isolator key and turn in the indicated direction.
19
Please consult your manual for full information or consult your local dealer
Battery Isolator (where fitted)
A.
Isolator switch
