JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
CHARGING PROCEDURE
NOTE:
Before using the
tool, read the safety and
operating manual carefully.
CHARGING INSTRUCTIONS
1. CHARGING YOUR
BATTERY PACK
Warning:
The charger and battery
pack are specifically designed to
work together so do not attempt to
use any other devices. Never insert
or allow metallic objects into your
charger or battery pack connections
because an electrical failure and
hazard will occur.
2. BEFORE USING YOUR
CORDLESS TOOL
Your battery pack is UNCHARGED
and you must charge once before
use. When you charge the new
battery or one which has not been
used for long periods of time, it may
not reach full charge until after you
have discharged it fully in use and
recharge it several times.
3. HOW TO CHARGE YOUR
BATTERY
CHARGING PROCEDURE
1) Plug the charger into an
appropriate outlet. The light will be
green.
2) Insert the battery pack into the
charger, the light will be red to indicate
the charging process has started.
3) On completion of charge, the
logo will turn to be green. The pack
is now fully charged, unplug the
charger and remove the battery
pack.
Warning:
When battery charge runs
out after continuous use or
exposure to direct sunlight or
heat, allow time for the tool to
cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect
some problems that can arise
with battery packs. Indicator lights
indicate problems (see table below).
If this occurs, insert a new battery
pack to determine if the charger
is OK. If the new battery charges
correctly, then the original pack is
defective and should be returned
to a service center or recycling
service center. If the new battery
pack displays the same problem
as the original Battery Pack, have
the charger tested at an authorised
service center.
Indicator
ON/
OFF
flash
Status
Red on
Charging
