jcb JCB-BC26, Safety And Operating Manual Original Instructions

Page: 4 / 24

SO53 3LE
Customer Helpline 0845 600 5526 Monday to Friday 09.00 to 17.00
www.JCBdiy.com
FOR TRIMMER

Replace string head if cracked, chipped or damaged in any way. Be sure the string
head or blade is properly installed and securely fastened. Failure to do so can
cause serious injury.

Make sure all guards, straps, deflectors and handles are properly and securely
attached.

Use only the manufacturer's replacement line in the cutting head. Do not use any
other cutting attachment.

Never operate unit without the grass deflector in place and in good condition.

Maintain a firm grip on both handles while trimming. Keep string head below waist
level. Never cut with the string head located more than 76 cm above the ground.
FOR BRUSHCUTTER AND BLADE

After engine stops, keep rotating blade in heavy grass or pulpy weeds until it stops.

Do not operate the brushcutter unless the blade guard is firmly secured in place
and in good condition.

Use heavy gloves while installing or removing blades.

Always stop the engine and remove the spark plug wire before attempting to
remove any obstruction caught or jammed in the blade or before removing and
installing the blade.

Do not attempt to touch or stop the blade when it is rotating.

A coasting blade can cause injury while it continues to spin after the engine is
stopped or throttle trigger released. Maintain proper control until the blade has
completely stopped rotating.

Replace any blade that has been damaged. Always make sure blade is installed
correctly and securely fastened before each use. Failure to do so can cause serious
injury.

Use only the manufacturer's replacement blade intended for use on this brushcutter.
Do not use any other blade.

The blade is suited for cutting pulpy weeds and vines only. Do not use for any other
purpose. Never use the blade to cut woody brush.

Exercise extreme caution when using the blade with this unit. Blade thrust
is the reaction that may occur when the spinning blade contacts anything
it cannot cut. This contact may cause the blade to stop for an instant, and
suddenly “thrust” the unit away from the object that was hit. This reaction
ADDITIONAL SAFETY RULES
JCB-BC26_960443002-01_Manual_final.indd A4 JCB-BC26_960443002-01_Manual_final.indd A4 12/2/2010 5:37:59 PM 12/2/2010 5:37:59 PM