14
JCB-20CD
Instruction & User Manual
OPERATING INSTRUCTIONS
Intended Use
This combi drill driver is intended for drilling
and screwing/unscrewing screws in masonry,
wood, plastic and metal.
The power tool must not be modified or used
for any other purposes than the ones described
in these instructions.
Battery
Make sure the power tool ON/OFF Trigger
is not operated when inserting or removing
the battery. Use with JCB batteries only:
JCB-20-15LI, JCB-20-20LI, JCB-20-30LI,
JCB-20-40LI and JCB-20-50LI.
NOTE
m
Do not use excessive force when
inserting or removing the battery
pack from the charger or power
tool.
An incorrectly connected battery can
damage the battery terminals or the battery
socket on the power tool or charger.
m
Use the button on the battery to check the
charging status; 4 red LEDs indicates fully
charged, where 1 indicates low battery
status.
Charging The Battery
After charging for the first time, ensure the
battery is completely discharged before
placing on charge again. Repeat this charging
and discharging cycle 4 to 5 times to ensure
battery is correctly conditioned.
WARNING!
m
Place the battery charger on a level and
stable surface. Connect the battery pack to
the charger so that it clicks in to place.
m
Plug the charger into a suitable power
supply. Note: ensure the voltage on the
charger rating label matches the power
supply voltage
m
Refer to the Battery Charge Level table
below for battery charger status as indicated
by LED lights.
m
When fully charged, unplug the charger
from the power point and remove the
battery from the charger.
Battery Charge Level
Red
LED
Green
LED
Battery Charge Status
Charger is connected to
mains power
Connected battery is
charging
Connected battery is fully
charged
Connected battery has a
charging fault
Charger is outside correct
operating temperature
range (<0˚C / >40˚C)
If the LEDs on the charger do not come on
when charging:
m
Check that the charger’s mains adaptor is
properly plugged into the power point and
that the charger is switched on
m
Check that the battery is correctly inserted
in the charger
