18
JCB-20CD
Instruction & User Manual
m
Use the high speed mode for drilling small
holes.
Maintenance
Switch off the power tool and disconnect
the power (remove battery/unplug) before
cleaning and maintenance. This helps avoid
the risk of electric shocks and accidental
starting.
WARNING!
m
Wipe the power tool with a dry or damp
cloth.
Do not use a wet cloth.
Do not
use detergent that contains solvent
or corrosive, abrasive additives.
This
risks damaging the surfaces of the power
tool.
m
Clear the power tool vents and the
accessory mount of dust and dirt after each
use.
Do not clean ventilation holes by
inserting sharp objects in them, such
as screwdrivers and other similar
objects.
m
Stubborn contamination in areas hard to
access can be removed with compressed air
(max 3. bar).
m
Regularly check all fasteners, screws and
bolts to make sure that they are tight.
Tighten any loose screws immediately or
serious injury could occur.
Transport and Storage
m
If the power tool will remain unused for any
length of time, it should be stored in the
original packaging.
m
Store the power tool and battery in a dry,
frost-free, well ventilated place.
m
Keep all power tools out of the reach of
children.
m
Always switch off the power tool and
disconnect it from the power supply
(remove the battery/unplug the power
cord) before transport.
m
Always carry the power tool using the
purpose-designed handle.
m
Ensure that the power tool is not at risk
of tipping over or exposed to excessive
vibration and shocks during transport,
especially if the tool will be transported by
car or other vehicle.
Never open the power tool. The power
tool has nointernal parts that the user can
service or repair. Never try to repair the
power tool yourself. Take to an authorised
service centre.
WARNING!
Operating temperature: 0-40 °C
Storage temperature: 20-60 °C
NOTE
