Rated thermal power
9,8kW
Useful thermal power emitted in the room
9,8kW
Energy efficiency
81,7%
Minimum distance between the glass pane of the appliance and all combustible materials
1200mm
Minimum distance between the side of the appliance and any combustible materials
1200mm
Minimum distance between the bottom of the appliance and any combustible materials
340mm
CO (13% O2)
0,11%
PM (13% O2)
29 mg/Nm3
CO2
4,78%
Smoke temperature
138°C
Smoke temperature at the nozzle outlet
166°C
Minimum draft - Nominal draft
12 Pa
Fuel
Dry wood logs 30cm lenght
Recommended wood load
2 logs of 1kg lg30cm split in ¼
Type of combustion
Intermittent combustion
Refuelling intervals
45min
Mass flow rate of smoke
16,3 g/s
Smoke discharge diameter
Ø200mm
Air inlet diameter
100cm²
Mass of appliance only
120kg
Airtight according to EN 16510-1
NO
If tight, leakage under 10Pa according to EN 16510-1
/
Mass per meter of additional extension
20kg
Energy efficiency index
108
In the case of a wall appliance, the back wall must be made of non-combustible material
*The back wall must be made of a non-combustible material and provided with insulation over the entire surface within the
construction right-of-way. This insulation must have a reaction to fire classification M0, A2s1d0 or A1 and a thermal resistance
greater than 0.7m².K / W (measured at 50 ° C). The insulation must not be able to degrade at temperatures below 400 ° C (for
example, calcium silicate, mineral rock wool, etc.)
In the event that the back wall is made of combustible material, it is necessary either:
-remove the combustible material and install insulation as described above.
-or put a partition in non-combustible material at least 2cm from the wall in combustible material and ventilate through two
openings (bottom and top). An insulation must then be put on the partition created in the same way as seen previously.
TECHNICAL INFORMATION
FREE-STANDING LEA
WALL MOUNTED LEA
