27
FNS-0012-060-EN June 2019 Rev A
Self Service Option Cleaning Instructions (continued)
11. If possible, hose down juicing area and cover.
If location prohibits using a hose to clean juicing area and cover, ensure waste container is in place.
Wash down the exposed juicing area and cover with a sponge or spray applicator using the
recommended cleaning solution. Cover may be rinsed in place or removed by lifting it off the hinges.
Allow to stand for two minutes before rinsing thoroughly with water.
12. Re-assemble juicing components.
Start by re-assembling strainer tube into juice manifold. Tighten with spanner wrench. Insert orifice
tube into bottom of strainer tube. Mount juice manifold assembly onto locating pins with orifice tube
notch engaging lower drive. Tighten spanner screw with spanner wrench. Remove red protective
cap from cutter. Install lower cup and tighten spanner nuts with spanner wrench. Install upper cup
by slipping pin into stem hole. Install splatter shield.
Refer to Figure 1.
13. Verify that orifice tube is properly installed (Figure 2).
14. Remove wax build-up as needed.
Cups, hopper and other parts may acquire a build-up of wax over time.
a. Soak cups for five minutes in Veggie Wash solution to remove wax.
b. Use Veggie Wash solution to remove wax from hopper and other areas to remove wax build-up.
15. Remove orange discoloration as needed.
Equipment may exhibit some build-up or orange coloration over time. CorKlean solution should
remove this. Wipe with a cloth soaked in any pine based cleaner to remove discoloration from
plastic covers.
Rinse thoroughly with sanitizer solution.
16. Clean self-service housing and spout.
Daily cleaning is crucial to the performance, maintenance and sanitation of the self-service
assembly. After the self-service assembly is removed from the machine, remove the spout cap
assembly by rotating it counter clockwise 1/4 turn and then lifting the entire assembly from the spout
body. Depress the seal plug and remove the handle to disassemble. Rinse cap, spring, stem and
seal plug with clean water and sanitize. Rinse housing and flush spout body with clean water and
sanitize. Note that removal of the spout nozzle from the housing is not required for proper cleaning.
Summary of Contents for Fresh'n Squeeze 2nd Generation Multi-Fruit Juicer
