Gateway C102/C112 Reference Guide
Page 8
© JBM Electronics Co.
1-800-489-7781
www.jbmelectronics.com
At the ‘Unit Parameters’ screen, highlight the ‘Define Remote Access Information’
field and press <Enter>. This will allow you to customize the LAN properties of
the Gateway.
Note:
The Define Remote Access Information Field configures the LAN
properties for the Gateway 50 through 80 units only. The Gateway 100 through
900 series and the Gateway 1000’s LAN information is configured at the Linux
prompt by issuing the command niccfg eth0. Once the command has been
issued, you will be prompted to enter the correct IP information. If you are using a
G100-G1000 series unit, simply navigate into the Define Remote Access screen
and then press F12 to return to the Unit Paramters screen leaving the fields on
the Remote Access Information screen blank.
