SDP-3 Digital Surround Processor/Controller
Installation
11
2
Restore Factory Defaults
Although the SDP-3 memory is cleared before it leaves the factory, it is
good practice to restore the factory defaults with the following procedure
before system configuration.
Turn the SDP-3 OFF with the remote control. Turn the unit back ON and
immediately press and hold the MUTE button on the remote. (Make sure
you do not block the infrared receiver on the SDP-3 front panel.) The
display will read:
Press
▼
to highlight RESTORE DEFAULTS, then press SELECT. This
will clear and reload all preset effects and all factory settings of Volume,
Balance, Contrast, Configuration, etc. When the message FACTORY
DEFAULTS RESTORED is displayed, press DONE to return to normal
operation.
Equalization
In the main menu, press SELECT to open the Equalization menu which
contains Bass, Treble and Tilt controls, and a Loudness parameter.
FACTORY PRESETS MENU
EXIT
RESTORE DEFAULTS
MAIN MENU
SETUP
EFFECT ADJUST
EQUALIZATION
DISPLAY ADJUST
EQUALIZATION MENU
BASS LEVEL
TREBLE LEVEL
TILT
LOUDNESS
-6.0 to +6.0dB
-6.0 to +6.0dB
-3.0dB to +3.0dB
ON, OFF
▲
▼
Adjust with or
+0.0dB
+0.0dB
+0.0dB
ON
System Configuration
Bass and Treble Level
Bass and Treble level controls are provided to compensate for inconsis-
tencies in source material, rather than variations in room conditions. The
BASS LEVEL control allows a boost or cut of as much as 6dB below
250Hz. The TREBLE LEVEL control allows a boost or cut of 6dB above
1.5kHz. To select either control for adjustment, use
▲
or
▼
to select the
control, press SELECT, and use
▲
or
▼
to adjust the setting.
These controls do not affect the sound of rear or side speakers.
