www.jbl.com
ENGLI
SH
5
Volume controlS
Volume increase “+”
Volume decrease “–”
Answer/end phone call (MFB) “ ”
Microphone “ ”
Battery InStallatIon
Rotate the battery compartment cover on the bottom of the
1.
JBL On Tour iBT speaker to the unlocked
position; remove the battery compartment cover.
Place (4) fresh AA batteries as shown.
2.
Replace the battery compartment cover.
3.
Note: The JBL On Tour iBT will not use battery power when using AC power.
1.
2.
3.
DO NOT MIX BATTERY TYPES.
DO NOT MIX CHARGED AND PARTIALLY CHARGED BATTERIES.
BATTERIES WILL NOT RECHARGE WHILE IN THE UNIT.
caUtIon:
Risk of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
Battery dISpoSal
Alkaline batteries are considered nonhazardous. Rechargeable batteries (i.e., nickel cadmium, nickel
metal-hydride, lithium and lithiumion) are considered hazardous household materials and may pose an
unnecessary health and safety risk.
In the European Union and other locations, it is illegal to dispose of any battery with household trash. All
batteries must be disposed of in an environmentally sound manner. Contact your local waste management
offcials for information regarding the environmentally sound collection, recycling and disposal of used
batteries.
Bluetooth
paIrInG
Before you can use your JBL On Tour iBT system with a
Bluetooth
-enabled device, you must pair it with that
device.
To pair the JBL On Tour iBT with your device:
Make sure your
1.
JBL On Tour iBT system is turned on. The JBL On Tour iBT unit automatically goes into
Pairing/Discoverable mode, represented by the Source LED flashing blue.
2. Put your
Bluetooth
-enabled device in Pairing mode so both devices can “see” each other. (Refer to the
Bluetooth
-enabled device’s user’s guide for directions and details about putting it into Pairing mode.)
The JBL On Tour iBT unit will be represented as “JBL On Tour iBT” on your
Bluetooth
-enabled device. The
JBL On Tour iBT password is 0000.
The
3.
JBL On Tour iBT system is successfully paired and ready to use when the Source LED glows a
constant blue.
note:
Bluetooth
pairing between two devices does not have to be repeated after a successful initial
pairing, unless the JBL On Tour iBT system has been removed from the
Bluetooth
-enabled device’s
Bluetooth
device list.
0288CSK - JBL On Tour iBT v10.indd 5
06/05/11 13:31:05
