JBL A6000GTi, Service Manual, Page: 24 / 62

137159-1 Rev. 1 A6000GTi Service Manual

2003 Crown Audio, Inc.
Maintenance 4-5
4.3.3. Power Connection Housing Removal
1. Peel the rubber pad off bottom of the amp.
2. Using a T-15 screwdriver, remove the four Torx-head screws from the bottom of the
amplifier holding the plastic power housing to the chassis.
3. Using a flat-head screwdriver pry off the red and black caps from power connectors.
4. Using a 3/16-inch Allen wrench, remove the two cap head screws in the power
connectors. Then remove the two power connectors and washers.
5. Using a T-15 screwdriver, remove the 2 Torx-head screws on the plastic plate on top of
the speaker output connectors.
6. Using a T-15 screwdriver, remove the 2 Torx-head screws on the back of the output
board.
7. Disconnect cable from REM board.
8. Disconnect Sensor cable from the power supply PWA.
9. Remove plastic power housing (see Figure 4.6).
Figure 4.6 Power Connection Housing
Plastic Power
Housing
Rubber Pad
REM Board
Sensor