jbc advanced Series, Manual

Page: 3 / 88

2
ENGLISH
SPECIFICATIONS
The AR 5500 is a repair station for desoldering
through-hole components by solder intake.
- AR 5500 230V Ref. 5500200
It is supplied with a desoldering iron Advanced DR
5600 and Advanced 2245 soldering handpiece.
Also all the Advanced soldering handpieces and the
hot tweezers
PA 1200 or PA 4200 can be connected
to the station.
The station’s components
- Handpiece 2245 Ref. 2245000
with the cartridge 2245-003 Ref. 2245003
- Desoldering iron
DR 5600
Ref. 5600000
with the tip 5600-003 Ref. 5600003
- Soldering iron stand AD 8200 Ref. 0268200
- Desoldering iron stand DR 8500 Ref. 0788500
- External desoldering air filter Ref. 0821830
- Spare filters Ref. 0781046
- Set of accessories Ref. 0780593
- Instruction manual Ref. 0780465
The A R 5 5 0 0 s t a t i o n h a s t h e f o l l o w i n g
complementary products:
- Handpiece 2010 Ref. 2010000
- Handpiece 2210 Ref. 2210000
- Handpiece 2045 Ref. 2045000
- Micro hot tweezers PA 1200 Ref. 1200000
- Hot tweezers PA 4200 Ref. 4200000
Control Unit technical specifications
- Maximum power soldering iron 50W.
- Maximum power desoldering iron 75W.
- Temperature selection of the soldering part:
100 to 371
°
C (
±
5%).
- Temperature selection of the desoldering part:
100 to 371
°
C (
±
5%).
- Station's maximum power: 175W.
- ESD protected housing.
Typical surface resistance: 10 5 -10 11 Ohms/square
- Complies with CE standards on electrical safety,
electromagnetic compatibility and antistatic
protection.
- Equipotential connector is earth connected to the
plug feed of the station.
- Weight of complete unit: 10.6 kg.
- In the SOLD. connector you can only connect
handpieces 2010, 2210, 2045 and 2245 and the
hot tweezers PA 1200 or PA 4200.
- In the DESOLD. connector you can only connect
the desoldering iron DR 5600.
RECOMMENDATIONS FOR USE
For soldering and desoldering
- Clean the contacts and the printed circuit to
be desoldered of dust or dirt.
- Preferably select a temperature below 350
°
C.
Excess temperature may cause the printed
circuit tracks to break loose.
- The tip must be well tinned for good heat
conduction. If it has been inoperative for any
length of time, it should be retinned.
Safety measures
- Incorrect use of this tool may cause fire.
- Be cautious when using the tool in places
where inflamable products are stored.
- Heat can fire up inflamable products even
when they are not at sight.
- Do not use when the atmosphere is explosive.
- Place the tool back on its stand in order to let
it cool down before you store it.