JB Systems Plano Spot 7TC, Operation Manual

Page: 5 / 29

ENGLISH OPERATION MANUAL
JB SYSTEMS ® 5/54 PLANO SPOT 7TC
ENGLISH OPERATION MANUAL
JB SYSTEMS ® 6/54 PLANO SPOT 7TC
DMX512 Address Setting
Used to set the start address in a DMX setup, you can also automatically program the next PLANO
SPOT projectors in the same DMX-chain.
Program a DMX start address in 1 unit:

Press the MENU button until is shown on the display.

Press the ENTER button to select.

Use DOWN and UP buttons to change the DMX512 address.

Once the correct address is shown on the display, press the ENTER button to confirm.

Press the MENU button for about 2 seconds to return to running mode.
Automatically program the DMX start addresses of several units in a DMX-chain:

Connect the DMX in/outputs of all projectors together and switch them all on

On the first unit in the chain:

Press the MENU button until is shown on the display.

Press the ENTER button to select.

Use DOWN and UP buttons to change the DMX512 address.

Once the correct address shows on the display, press 2 times the ENTER button.

After this, use the DOWN and UP buttons until is shown on the display.

Press the ENTER button to start the automatic programming  all units flash one time to indicate
that the addresses are automatically set, starting from the address programmed in the first unit.

Press the MENU button on the first unit for about 2 seconds to return to running mode.
Example: the first projector was set to DMX-address 100  when you perform the automtic
addressing, the other projectors in the DMX-chain will receive addresses: 104, 108, 112, 116, …
Channel Mode
The unit has 4 different channel modes, each with different functions for the 4
th
channel. Refer to the
DMX-chart to see the differences.

Press the MENU button until is shown on the display.

Press the ENTER button to select.

Use DOWN and UP button to select one of the available channel modes.

Once the mode is selected, press the ENTER button to confirm.

Press the MENU button for about 2 seconds to return to running mode.
Show Mode
Used to choose to select one of the preprogrammed multi channel shows when used in standalone
or master/slave mode.

Press the MENU button until is shown on the display.

Press the ENTER button to select.

Use DOWN and UP buttons to select one of the preprogrammed shows:

 all shows played in random mode.

to  12 different built-in shows.

Except for the random show (Show 0) you will also be asked to select a running speed for the static mode.
With the UP/DOWN buttons you can select
(slow) to (fast).

Once the right show is selected, press the ENTER button to confirm.

Press the MENU button for about 2 seconds to return to running mode.
Color chase Mode
Used to choose to select one of the preprogrammed colorfades when used in standalone or
master/slave mode. All projectors will always show an identical output.

Press the MENU button until is shown on the display.

Press the ENTER button to select.

Use DOWN and UP buttons to select one of the preprogrammed shows

You will also be asked to select a running speed for the static mode. With the UP/DOWN buttons you can
select
(slow) to (fast).

Once the right show is selected, press the ENTER button to confirm.

Press the MENU button for about 2 seconds to return to running mode.