ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
5/37
LED DEVIL
Important: On the master unit the DMX address MUST be set to 001.
(first DIP switch = ON, all other are
OFF)
The slave units can have any DMX address value but NOT 001!
You can inverse the behavior of one or more slave units by changing the position of DIP-switch n°10 on
these slaves. Just try it and see if the effect becomes better. Changing DIP-switch n°10 on the master has
no effect.
3. Connect the optional CA-8 controller for more control:
The CA-8 controller can only be used in standalone or master/slave mode. Connect the
controller to the jack input of the first unit (master). Now you can control all the connected
units:
Stand by
Blackout the unit (LED ON)
Function
Push for
1. strobe function
2. 2 light strobe
3. Sound strobe
Rotation speed selection
1-8
Mode
Musical mode (LED OFF)
automatic mode(LED ON)
4. DMX-mode:
When the units are connected in DMX-mode, they can be controlled using the following
DMX-charts:
1 CHANNEL MODE
3 CHANNEL MODE
ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
6/37
LED DEVIL
MAINTENANCE
Make sure the area below the installation place is free from unwanted persons during servicing.
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit’s optics.
Clean with a soft cloth using normal glass cleaning products.
Always dry the parts carefully.
Clean the external optics at least once every 30 days.
Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input:
AC 100V ~ 240V, 50/60Hz
Max. Link up capacity IEC in/outputs:
45pcs
Fuse:
250V T6,3A slow blow (20mm glass)
Sound Control:
Internal microphone
DMX connections:
3pin XLR male / female
DMX channels used:
1 + 3 channels
Lamp:
1x RGB LED 10Watt
Size:
172 x 215 x 195 mm
Weight:
3,3kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
