- 6 -
5. Fix the opener to the ceiling joist or suitable support using fasteners suitable for the fixing material (not supplied)
and observe the fastener manufacturers guidelines, uses and ratings.
6. Fix the door bracket(A) to the top edge of the door in the middle and under the wall bracket using suitable fasteners
(not supplied)
7. Connect the bent arm(G) to the door bracket using the
Φ
8x25 axle pin and cotter pin as shown in Fig.5.
8. Install the shuttle(D) to the track using the 4x M6x20 screws supplied (Fig.6), tie the clutch cord. Connect the
straight arm(H) to the clutch using the
Φ
8x25 axle pin as shown in Fig.5. Affix manual release procedure
instruction card to clutch cord/manual release cord.
9. Connect the bent arm and straight arm using M8 outer hexagon bolts and nuts supplied (before connecting, adjust
to a suitable length)
10. Release the clutch, try to open and close the door by hand. Make sure there is no contact between door panel and
track.
11. Connect the opener to power.
Notice
: Make sure the opener’s voltage is in accordance with the local voltage. Connect the opener to a properly
earthed power supply.
Track Assembly
–
Only required for segmented rails
Confirm the type of segmented rail
you have according to Fig7.
Skip this step if you have a 1piece
rail.
Fig.7
Install the rails according the steps
in Fig8:
A. Connect the rails by the sleeve;
B. Follow the steps in the picture to
connect the rails
C. Move the pulley to the top end
of the rail after the rails are
connected
D. Stretch the screw bolt of the
pulley into the hole on the rail.
Install the spring, washer, and
adjusting nut. Adjust the nut to a
suitable position, the installation of
the rail is complete.
Fig.8
2 IN 1
4 IN 1
3 IN 1
