Jayco Qwest, Owner'S Manual, Page: 55 / 86

5. Each stove assembly will have a hinged wind guard attached. Raise hinged assembly
to vertical position. End panels are also hinged and will swing to outer edge of stove
for wind protection, preventing flames from reaching tent material.
Operating instructions for stove are below. Additional information can be found in the
manual supplied by manufacturer of stove.
Operation of Stove
1. To light the top burners:
a. Turn the appropriate burner knob fully counterclockwise to the “Lite” posi-
tion. Do not attempt to light more than one burner at a time.
b. IMMEDIATELY light the burner by holding a lit match or a hand-held spark
igniter designed for this purpose near the burner ports.
c. Set temperature.
d. To extinguish the top burner flame, turn the appropriate burner knob clockwise
to the “OFF” position.
2. To remove the stove top:
a. Loosen screws
b. Lift free.
NOTE: If flames lift off the burner there is too much pressure in the gas line, or if
the flame flashes back into the burner tube there is not enough pressure in
the gas line. Under both conditions, discontinue use and have your regulator
checked by a qualified service center.
CAUTION: When cleaning any orifice or the burner assembly, care must be used
to prevent damaging or enlarging the openings. Never use a wire or other metallic
implement to clean an orifice or burner post. Any enlargement of an orifice or burner
ports will affect the gas flow and, consequently, the burner’s function.
WARNING: Keep privacy drapes in the upper most position while cooking
on the range top to prevent fire hazards.
47