Jayco Qwest, Owner'S Manual, Page: 48 / 86

A warning label has been located near the LP gas container. This label reads:
THIS GAS PIPING SYSTEM IS DESIGNED FOR USE OF LIQUEFIED
PETROLEUM GAS ONLY. DO NOT CONNECT NATURAL GAS
TO THIS SYSTEM. DO NOT FILL CONTAINER(S) TO MORE
THAN 80 PERCENT OF CAPACITY. Securely cap inlet(s) when
not connected for use. After turning on gas, except after
normal container replacement, test gas piping and connections
to appliances for leakage with soapy water or bubble solution.
Do not use products that contain ammonia or chlorine.
AD-34
Installing LP Containers
1. Place container onto steel angle rack.
2. Insert 2-
1
/
4
" x
1
/
2
" bolts through hole in
center of angle.
3. Attach lock washer and nut onto bolt.
CAUTION: Ensure that all fasteners are secured before traveling.
OPD Overfill Protection
Supplied with your folding camping trailer is information that applies to the Type 1
ACME LP Gas Connection on your LP gas container(s). Please read all information
contained in the supplied literature.
The following instructions will supply information for correct cylinder/valve orientation,
regulator placement, hose length, hose routing and cylinder cover placement. Make sure
these steps are followed for proper LP connections.
SINGLE CYLINDER MOUNTED ON A-FRAME
1. Connect the 3/8" low pressure hose to
the outlet of the two stage regulator.
2. Attach the regulator with the “Z” bracket
on the center of the front wall with the
vent pointing down.
3. Attach the protective plastic cover to the
regulator.
4. The regulator has a 90° elbow that directs
the inlet toward the trailer curbside.
5. Place the cylinder on the bracket pro-
vided on the A-frame and position it so
the outlet of the cylinder valve is pointed
directly outward to the curbside wall.
6. If a vinyl cylinder cover is provided, slip it over the cylinder and leave the zipper
open.
Fig. 4-5
40