Jayco 2016 Melbourne, Owner'S Manual

Page: 67 / 169

57
S
lideOut
S
yStemS
Manually pushing in the slideout
1. Locate the slideout system controller
2. Unplug motor 1 and motor 2 connectors at the bottom of the slideout controller. This
releases the motor brakes for each motor.
3. The slideout room can now be manually pushed in. Larger rooms may require several
people to push or pull them.
4. Keep both sides of the slideout relatively even while pushing/pulling.
5. When the room is completely in, plug both motor connectors back into the control
module. This will apply the motor brakes for road travel.
Disengage motors, manually retract the room and travel lock
6. Locate and remove the motor retention screw which can be found near the top of each
vertical column (Fig. 3).
7. Bend back the wipe seal and visually locate the motor (Fig. 4).
8. Pull the motor up until it disengages (about 1/2 inch).
9. Repeat this process for both sides of the slide room.
10. Physically push or pull the room back into the opening, keep both sides relatively even.
11. The room must be travel locked to keep the room in place for road travel.
Error Codes
When an error code occurs during operation, the board will use the LEDs lights to indicate
where the problem is. For motor specific faults the green LED will blink (1) time for motor
#1 and (2) times for motor #2. The red LED will blink from 2 to 9 times depending on the
error code. Error codes are as follows:
2 times Battery drop out: battery capacity low enough to drop below 6 volts while running.
3 times Low battery: voltage is below 8 volts at the start of a cycle.
4 times High battery: voltage is greater than 18 volts.
5 times Excessive motor current: high amperage, also indicated by (1) side of the slide
continually stalling.
6 times Motor short circuit: motor or wiring to motor has shorted out.
8 times Hall signal not present: encoder is not providing a signal; usually a wiring problem.
9 times Hall power short to ground: power to encoder has been shorted to ground; usually
a wiring problem.
When an error code is present, the board needs to be reset. Energizing the extend / retract
switch will reset the board. Energize the extend / retract switch again to go back to normal
operation.
DO NOT MOVE THE RV UNLESS THE MOTORS ARE PLUGGED IN
TO THE CONTROLLER AND THERE IS BATTERY POWER TO THE RV.
THIS SETS THE BRAKES ON THE SLIDEOUTS TO PREVENT THEM
FROM MOVING DURING TRANSIT.

Table of Contents Maintenance Record