Jayco 2016 Melbourne, Owner'S Manual

Page: 140 / 169

130
e
lectrOnicS
Rotate the antenna knob to illuminate the last flickering LED.
Refer to your TV (or converter box) manual for information on how to scan for
available channels.
Refer to the HDTV manufacturer’s manual for detailed operating and safety information.
t
elevision
r
oof
A
ntennA
(
if so equipped
)
To view local stations at either (or both) the front or bedroom television sets using the
television antenna, make sure the TV power supply is ON and the TV roof antenna is raised
to the operating position.
The following is an overview of the antenna operation. Refer to the manufacturer’s user
guide for detailed operating instructions.
Raising the antenna
To raise the TV antenna to the operating position turn the
antenna elevating crank clockwise in the UP direction
(approximately 13 turns) until some resistance to turning is
noted.
On amplified models, 12-volt DC power is required. After
the antenna is in the full UP position, pull down on the round
knob with both hands until it disengages from the ceiling
plate. Rotate the knob for best picture.
To Test
1. Make sure the television set is working properly.
2. Switch the power supply ON and OFF to see if there is
a difference in the picture quality while watching TV.
If there is no difference, refer to manufacturer’s manual for further testing procedures.
Lowering the antenna
Rotate the antenna until the pointer on the directional handle aligns with the pointer on
the ceiling plate. Turn the elevating crank counterclockwise in the DOWN direction until
resistance is noted. The antenna is now locked in the travel position.
DO’S
Check parking location for obstructions before raising antenna.
Carefully raise, lower and rotate. If this is difficult, check for cause.
The TV power supply should be turned OFF when connecting/disconnecting
the cables to the power supply and antenna, but should be turned ON when
testing for voltage.

Make sure the television antenna is in the travel position (cranked down)
before moving the recreation vehicle. Failure to lower the antenna into the
travel position before traveling may damage the antenna.
