Jay electronique ISIS Series, Installation And User Technical Manual

Page: 70 / 156

- 70 -
ISIS
- 331260D
revision02
FR DE EN
6 - Changing the factory confi guration
6.1- Preliminary remarks
To ensure the uniqueness of the
ISIS
installation and avoid
any unintentional interference with another system, we strongly
recommend that you customize the factory con fi guration
(con fi guration on delivery) of your products.
You can re-con fi gure your products in shop before installing and
using your equipment.
Important :
For safety reasons, it is preferable that the inputs not
be active during the recon fi guration procedure.
Transmitter ISE - Transmitter module of transceiver IST Transmitter ISE - Transmitter module of transceiver IST
1 2
ON
3 4 5 6 7 8
ID
=
"0"
"1"
 The identity code is programmed using the 8 «
ID»
DIP-switches
(cursor set to «ON» = 1).
Example :
 The other con fi gurations (radio channel, transmission mode
and transmit power) are programmed using the 8 «
CONFIG»
DIP-switches (cursor set to «ON» = 1).
cursor position
Identity code =
10101011
1 2
ON
3 4 5 6 7 8
CONFIG
"0"
"1"
= cursor position
Radio channel
(see table on next page)
Radio transmission mode
(transceiver IST = always on "ON" position)
1 (ON) = continuous radio transmission
0 (OFF) = intermittent radio transmission
Radio transmit power
(transceiver IST = always on "ON" position)
1 (ON) = 10 mw
0 (OFF) = 1 mW
Used only for transceiver IST
(see § " Synchronizing transceivers IST ")
1 (ON) = Active Sync
0 (OFF) = Sync Inactive