Work Description and Scope
Before
Putting
into
Operation
After
every
1,000 kni
3,000 km 6,000 km
In Case of
Need
Clutch and its adjustment
Check its function and adjust or replace it, if need be.
(See Section 3.11.)
x
Telescopic fork
Functional check or replacement, if need be.
(See Section. 8.21.)
x
Steering bearings
Check and replacement, if need be.
(See Section 8.22.)
x
Wheel bearings
They require no maintenance. If there is a clearance
in the bearings, replace them.
Have them replaced
in a special service.
(See Section 8.23.)
x
8.2. Torques
Use a torque wrench for tightening the screws and nuts. It is recommended to make occassionaly the check of
tightening, especially before a long drive. Check always torques at mounting or dismantling individual parts.
Torque Tables
Screw Torque
M 6 mm
8-12 N.m
M 8 mm
18-28 N.m
M 10 mm
40-60 N.m
M 12 mm
70-100 N.m
M 14 nun
110-160 N. m
M 16 mm
170-250 N.m
Engine drain plug
20-25 N.m
Rear brake lever screw
6-10 N.m
Sparking plug
15-20 N.m
Central springing unit
Front wheel axle nut
35-40 N.m
screws
35-40 N.m
Front wheel axle socket screw
15-20 N.m
Brake braket screws
Rear wheel axle nuts
50-60 N.m
upper
20-25 N.m
Swinging fork axle nut
30-35 N.m
lower
14-15 N.m
Lower beam screw
20-25 N.m
Handlebars Yoke screws
15-20 N.m
Upper beam screws
15-20 N.m
Brake hose screws
17-18 N.m
Engine bearing
Cylinder head nuts
10-12 N.m
Socket screw M8x53
10-15 N.m
Exhaust flange bolts
10-15 N.m
Socket screw - M8x100
25-30 N.m
Screws for plastic
3.5 - 4 N.m
17
