Description and Operation
Operation
Charging the Batteries
19
www.javad.com
D
ANGER
:
T
HE
BATTERIES
(
OR
BATTERIES
INSTALLED
)
SHALL
NOT
BE
EXPOSED
TO
EXCESSIVE
HEAT
SUCH
AS
SUNSHINE
,
FIRE
OR
THE
LIKE
.
Warning:
Do not attempt to open the battery pack.
Warning:
Do not disassemble the battery pack.
Warning:
Do not charge in conditions different than specified.
Warning:
Do not use other than the specified battery charger.
Warning:
Do not short circuit the battery pack.
Warning:
Do not crush or modify the battery pack
Power supply requirements
The socket-outlet shall be installed near the equipment and shall be easily accessible. A single external
power supply with 5 pin ODU connector or SAE connector is necessary to operate TRIUMPH-VS. If
external power supply has only SAE connector, Receiver-to-SAE power cable shall be used. The external
power supply needs to be Listed for US and Certified for EU countries, it needs also to be a Limited
Power Source and rated for Outdoor Use and have an output rated for 10...30 V DC, 5A. This may not be
the same range as other JAVAD GNSS products with which you are familiar.
C
AUTION
:
To avoid the introduction of hazards when operating and installing, before connecting of the equip-
ment to the supply, make sure that the supply meets local and national safety ordinances and
matches the equipment’s voltage and current requirements.
C
AUTION
:
Never attempt any maintenance or cleaning of the supply while plugged in. Always remove supply
from AC power before attempting service or cleaning.
Warning:
If the voltage supplied is below the minimum specification, the receiver will suspend operation. If the voltage
supplied is above the maximum specification, the receiver may be permanently damaged, voiding your
warranty.
Make sure cords are located so that will not be stepped on, tripped over, or otherwise subjected to
damage or stress. Do not operate equipment with a damaged cord or plug – replace immediately.
To reduce the risk of damage to the equipment, pull by the plug body rather than the output cord
when disconnecting the equipment.
Do not operate the supply if it has received a sharp blow, been dropped, or otherwise damaged. Do
not disassemble the supply.
Warning:
Before connecting the external power source and the receiver, make sure that the power source matches the
receiver’s voltage and current requirements.
Powering receiver
To charge the receiver internal batteries without removing, take the following steps:
• Plug the Receiver-to-SAE cable’s 5-pin connector into the power port of the receiver (14-578101-01).
• Connect the opposite end of this cable with the battery charger’-s SAE connector (22-570101-01).
