Jason International, Inc. •
501.771.4477
Page 4 of 9
Customer Service : 800.255.5766
Copyright © 2016 Jason International.
INSTALLATION INSTRUCTIONS (cont.)
PRE-INSTALLATION PROCEDURES
1. Place the bath on a flat surface in an area where it may be
drained
after
testing.
2. Never lift the bath by any portion of the therapy system
plumbing.
3. Place a plug or tape over the drain, fill the bath with water to
the overflow and allow standing for a few minutes.
4. Connect an extension cord to the control box to run the
equipment for ten (10) minutes. Inspect the system for
leaks.
5. Turn the system off and let stand for ten (10) minutes.
Inspect the bath for leaks carefully around the equipment, all
plumbing fittings and the door, any defect must be reported
to your dealer prior to installation in order to have it covered
under
warranty.
6. Check to ensure that your installation will conform to all
applicable codes and secure necessary permits. All
electrical and plumbing connections should be made by a
qualified professional.
NOTE: Failure to follow these pre-installation proce-
dures could result in voiding the warranty. The manu-
facturer will not be liable for the removal or installation
of the bath unit.
Figure 1
Figure 2
SILICONE BEAD
TILE
DRYWALL
DRYWALL
TILE
OPTIONAL
TILE FLANGE
KIT
OPTIONAL
INTEGRATED
TILE LIP
1" X 2"
SUPPORT
SCREW
SILICONE BEAD
SCREW
INSTALLATION PROCEDURES
1. Place the bath on a solid flat surface. Rotate the
adjustable feet until all feet come in contact with the
floor.
2. Plumbing hardware, such as facuet, hoses and waste/
overflow, should be installed prior to setting the bath in-
place.
3. 100% Silicone with mildew-resistant properties should be
applied between the water-resistant backer board and the
deck of the bath. Note: If you use a tile flange kit, modify the
framing to support the bath lip as shown in
Figure 1.
4. The extension panel can be installed for 60” (152cm)
opening installations.
See Extension Panel Installation
section.
5. The secondary door drain coupling is to be installed
horizontlly between the drain show and the drain tee as
shown in
Figure 2.
