Jasic EVO 2.0, Operator'S Manual, Page: 15 / 20

15
OPERATION OF THE WIRED FOOT PEDAL REMOTE CONTROL
Wired connection
Depending on the model and user interface of your EVO model the below instructions may differ, please
refer to your EVO product operating manual for further instructions.
Connecting your wired controller
Model dependent and prior to powering up your EVO
machine, when fitting either the 9 pin remote plug,
ensure you align the keyway when inserting the plug,
then rotate the threaded collar fully clockwise until
finger tight and shown right.
FRC - 01 (9 pin connector)
Welding current adjustment operation
After successfully inserting the connector plug of the wired foot pedal remote control to the machine,
power up your EVO machine and then enable the remote control function of the machine.
The wired foot pedal remote control can then be used for adjusting welding current in Lift TIG welding
mode.
Please Note:
For further information regarding the operation/setup of remote control, please consult your EVO
machine operating manual.
Remote Model Suitable machine Remote Control Function Range
FRC - 01
(9 pin connector)
EM - 160C / EM - 200C
EM - 200CT / EM250CT
ET - 200 / ET - 200P
ET - 200P ACDC
Adjust welding current in TIG mode only
15m
5m fitted as
standard