Jasic EVO 2.0, Operator'S Manual, Page: 14 / 20

14
OPERATION OF THE WIRELESS FOOT PEDAL REMOTE CONTROL
Wireless connection
Depending on the model and user interface of your EVO model the below instructions may differ, please
refer to your EVO product operating manual for further instructions.
Powering up your wireless controller
To power up your wireless foot pedal controller, press the power button of the wireless foot pedal
controller and the power indicator will then turn on.
To turn off your foot pedal, press and hold the power button and the device will be powered off.
Pairing up your wireless controller
Model dependent and following powering up the machine up but before welding, activate the wireless
connection option and blue indicator on the receiver module will flash.
At the same time, press the wireless "Connect" button of the wireless remote controller and after the
EVO machine control panel displays "OK" and the blue indicator will remain
‘ ON ’ this indicates that the
wireless connection is successful and the remote and machine have paired up.
Welding current adjustment operation
Following successful pairing of your wireless connection, press the power button of the remote controller,
and by pressing down on the pedal with your foot you will adjust the welding er current.
The current adjustment range is from the minimum output current to the maximum adjustable current
of the machine. For normal use of the remote controller, enable the remote function via the machine
control panel.
If the foot control is not operated for a period of time, it will enter into standby mode and then powers
down after 10s and 10 min, respectively.
When the battery of the wireless foot pedal controller is low, the indicator will flash.
PLEASE NOTE:
•
After successfully connecting the wireless remote controller, do not press and hold the wireless
"Connect" button again during normal use; otherwise, it will disconnect itself from the welding
machine. To reconnect the remote device, you would need to repeat the above steps of wireless
connection!
•
Please operate the wireless remote controller at a distance of more than 1m from the ground,
otherwise, the transmission distance will be affected!
•
For further information regarding the operation/setup of remote control, please consult your EVO
machine operating manual.
Remote Model Suitable machine Remote Control Function Range
FRC - 02
EM - 160C / EM - 200C
EM - 200CT / EM250CT
Adjusts welding current in Lift TIG mode only
30m
ET - 200 / ET - 200P
ET - 200P ACDC
Adjusts welding current in Lift TIG mode only