Jasic EVO 2.0, Operator'S Manual, Page: 13 / 20

13
DESCRIPTION OF THE WIRED AND WIRELESS REMOTE CONTROLS
Two foot pedal wired/wireless remote controls are available in this design, the FRC - 01 (wired 9 pin) and
FRC - 02 (wireless) remote and will adjust TIG welding current with the following EVO machine models:
•
EM - 160C & EM - 200C (FRC - 01 & FRC - 02)
•
EM - 200CT & EM - 250CT (FRC - 01 & FRC - 02)
•
ET - 200 & ET - 200P (FRC - 01 & FRC - 02)
•
ET - 200P ACDC (FRC - 01 & FRC - 02)
FRC - 01 Foot pedal wired remote controls:
A. Current adjustment foot operated pedal
B. Remote control connection cable
•
FHC - 01 wired with 9 pin control plug
FRC - 02 Foot pedal wireless remote control:
C. Current adjustment foot operated pedal
D. Adjustable carry handle
E. Control Buttons and indicator
•
Wireless connection button
•
Power on/off button
•
Power LED indicator
BATTERY REPLACEMENT FOR YOU WIRELESS REMOTE CONTROL
When the batteries of the wireless foot pedal controller are low, the indicator will flash.
The remote control is fitted with qty 3 1.5 AA type battery which are designed to last approximately
250hrs based of operation actions of the remote controller.
When required, please follow the below procedure when replacing the battery.
1. Carefully using a small screwdriver remove the cover retaining screw as shown in the image below
item (A).
2. Remove the battery protective cover (B).
3. Remove and then install the correct sized
and rated replacement batteries as shown
in the image right (C).
4. Now re - install the back cover of the remote
controller.
Please Note:
For further information regarding the operation/setup of the features
for the remote control, please consult your EVO machine operating manual.