12
INSTALLATION OF WIRELESS REMOTE CONTROL RECIEVER MODULE
An Installation of wireless receiver module
The below operation requires sufficient professional comprehensive knowledge of electrical
circuits and electrical safety. Make sure the input cable of the machine is disconnected from
the electricity supply and wait for 5 minutes before removing the machine covers.
6.
Following fitting the receiver module in place, you know need to connect the cable connector
to the main PCB as shown below.
7.
Fit the cable plug to the socket on the main board.
8.
Carefully place the left side machine panel back into position and
refit the screws.
Please Note:
For further information regarding the operation/setup of remote control, please consult your EVO
machine operating manual.
This image shows the main control board diagram
for inserting wireless module plug in to the PCB
socket for DC TIG machine.
This image shows the main control board diagram
for inserting wireless module plug in to the PCB
socket for AC TIG machine.
Summary of Contents for EVO 2.0
Page 1: ...1 Wired and Wireless Remote Control...
Page 20: ...20...