LTE910PS v1.00 User Manual JA16-UM
Page 15 Rev: 00 Date: 07/24/19
© Copyright 2019 Janus Remote Communications
Specifications subject to change without notice
All Rights Reserved See website for latest revision. Not intended for life support applications.
8. Specifications
Interfaces
Parameters
Description
Modem/Telephone
RJ11 connector (FXS)
Serial CONFIG
USB Mini -- user terminal interface for configuration and firmware upload.
Cellular Antenna
SMA; 3.3 V LNA bias voltage output.
GPS Antenna
50 ohm SMA w/ 2.85V bias (on TAGFNG models only)
Power Input
7-15 Vdc; 22W with two input alternatives:
-- 6mm DC power jack with 2mm center pin positive
-- 5.08mm (0.200”) terminal block header (accepts screw clamp
and crimp connector type terminal blocks)
Features
Parameters
Description
SLIC
Performs all BORSCHT functions:
Battery supply to subscriber line
Overvoltage protection
Ringing current supply
Supervision of subscriber terminal
Coder and decoder
Hybrid, 2 wire to 4 wire conversion
Testing
DTMF encoding and decoding
REN=5 at 100 ft. (30m)
Voice
VoLTE (4G) and Voice over cellular (3G fallback)
Cellular Connection
4G (LTE) bands 2, 4, 5, 12, 13, 14, 66 and 71. Plus 3G (fallback) bands 2, 4 and 5.
SIM Card
Micro (3FF size) SIM Card
Push Buttons
MODE, RESET
LEDs
Power, Status, Cellular Link, GPS and Signal Strength
Dimensions (L x W x D)
6.0 in (152mm) x 5.2 in (132mm) x 1.2 in (30mm)
Weight
13 oz (365 g)
Mounting
Integrated mounting brackets
Environmental
Parameters
Description
Operating Temperature
-40° C to +60° C (-40° F to 140° F)
(Note: Operating temperature may be further limited by specific Plug-In Terminus terminal)
Relative Humidity
5% to 95% (non-condensing)
