LTE910PS v1.00 User Manual JA16-UM
Page 11 Rev: 00 Date: 07/24/19
© Copyright 2019 Janus Remote Communications
Specifications subject to change without notice
All Rights Reserved See website for latest revision. Not intended for life support applications.
5. External Interfaces continued
CELL LED:
LED STATUS
CELLULAR RADIO
Green
Registered home or roaming
Red
Not Registered
* When the CELLULAR LED stays red (not registered) for more than a few minutes after powering the POTSwap, it is usually an indication of a poor
antenna connection or a problem with the activation on the cellular network. Check that the SIM card is properly installed and that it has valid
activation with a cellular carrier.
GPS LED:
LED STATUS
Indication
Green
GPS has location fix
Red
No GPS location fix
PUSH BUTTONS
Two push buttons are provided on the front panel of the POTSwap. These can be operated with a small diameter
object such as a paperclip. There is tactile feedback that indicates when the push button has been operated.
Applying pressure to the push buttons beyond the point at which they actuate can damage the switch.
The RESET push button performs the same function as powering the unit off and then on; the configuration
parameters are not affected.
PUSH BUTTON FUNCTIONS
PUSH BUTTON
FUNCTION
MODE
Future Use
RESET
System Restart
PHONE – FXS Connector:
Figure 5 RJ11 Jack
A standard RJ11 jack (6P2C – 6 position 2 conductor) supports the landline telephone interface.
This jack simulates what would be provided by a land-line based telephone central office, including power, ringing
signal and voice transport.
Any standard telephone device can be connected to this connector.
Under no circumstances should the PHONE – FXS connector be connected to
another powered telephone line – e.g. a telephone wall jack or PBX line.
