Page 6
MAINTENANCE AND CLEANING
TOP BOWL CLEANING
•
All parts of the top bowl should be cleaned with hot water in which you should add some detergent.
•
Rests of milk, cream or other impairs should be cleaned with soft duster or cleaning brush. Specially take care, that you clean
very precisely all the holes in top bowl upper part, top bowl bottom part and in adjusting screw. For cleaning this parts cleaning
brush is strongly recommended! Other parts of the separator that come in touch with milk, should also be cleaned with hot
water in which some detergent is added. Then rinse parts in clean water.
•
If milk or cream rests get dry do not remove them with sharp objects or sharp duster. It can easily happen that you ruin galva
-
nic protection cover or plastic parts.
•
Clean it first with wet duster and then try it with dry duster. Take care that water doesn´t come into the device.
THE DEVICE IS PROTECTED AGAINST DIRECT WATER ACCESS, BUT YOU SHOULD ALWAYS TAKE CARE TO
AVOID THAT WATER COMES INTO THE DEVICE.
1.
With the key, which is packed with the cream separator, unscrew top bowl fixing nut as it is shown on the picture. Fix key into
the holes, which are on the top bowl fixing nut.
2.
With stronger press on the other key end turn fixing nut until you release it. After that you can unscrew the nut easily with
hand.
1.
Dismount the top bowl cover with help of fixing nut key and separate all different pieces you will find under the cover - plastic
partition, top bowl discs and rubber washer and clear them with hot water. To achieve better results, cleaning detergent can be
added to the hot water.
2.
Wash all the parts with hot water and dry them with dry and soft duster.
PLEASE AVOID TO USE FORCE – YOU CAN HARM THE DEVICE MOST PRECISE PARTS.
