Page 4
ASSEMBLING PROCEDURE
TOP BOWL ASSEMBLING
1.
Put the housing on a stable surface (e.g. table or other plain and stable surface) in a clear and dry place.
2.
Take bottle with machine oil and pour whole capacity of machine oil into the housing through hole.
3.
Put hand crank on axe and fix with screw. Check if the handle is fix enough.
4.
Put assembled top bowl on the conical motor beam and softly press it.
5.
Put skimmed milk funnel on the top of the housing and then also cream funnel on the top of previous one.
6.
Turn top bowl with hand and check if is not touching one the funnels and adjust funnels to desired position for skimming.
7.
Place the holder for milk container on the top of both funnels. Place floating device in it.
Then place milk container on the top.
8.
Place closing cork in the hole situated in the middle of milk container. The narrow side of the
closing cork handle must be turned away from the cut in the container (see picture).
The milk outflow will be closed.
1.
Put the rubber washer in to the notch of top bowl bottom part.
2.
Place the top bowl discs. You have to take care by top bowl discs placement - device uses
two different types of top bowl discs - top bowl discs wiht hills A and flat top bowl discs B.
You have to place this two types of top bowl discs alternate, beginning with a top bowl disc
with hills A, and repeat the procedure until all top bowl discs are placed. By top bowl disc
placement avoid any use of force. With gently shaking and turning of the top bowl bottom
part all the top bowl discs will find their place very easily.
3.
Put plastic partition in the top bowl cover part.
4.
When assembling place both assembled parts of top bowl together. Take care that top
bowl cover part mark ˝0˝ and top bowl bottom part ˝0˝ are in the same direction.
5.
Screw the top bowl fixing nut with hand and fix it strongly with the fixing key. The mark ˝0˝
must stay in the same direction. The fixing nut must be strongly fixed, because it is expo
-
sed to high forces.
THE CLOSING CORK MUST BE CLOSED, WHEN YOU FILL THE CONTAINER.
THIS MEANS THAT THE THICK SIDE OF THE CLOSING CORK HANDLE MUST
BE TURNED TO OPPOSITE DIRECTION OF THE CUT IN THE CONTAINER.
