AAASewing.com
21
1
Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the buttonhole
marking running toward you.
2
Move the slider (A) toward you so that the top
mark (C) on the slider meets the start mark (B).
Line up the markings on the foot with the top mark
on the fabric. Lower the presser foot.
NOTE:The marking on the slider are engraved in
centimeters.
3
Set the stitch selector at . Sew forward until
you reach the front marking of your buttonhole.
Stop sewing at a left stitch.
4
Set the stitch selector at . Sew four (4) to six
(6) stitches. Stop sewing at a right stitch.
5
Set the stitch selector at . Sew until you reach
the back marking of the buttonhole. Stop sewing
at a right stitch.
6
Set the stitch selector at . Sew four (4) to six
(6) stitches. Stop sewing at a left stitch.
7
Remove the fabric and open a hole with a seam
ripper/buttonhole opener.
1
2
3
4
5
2
Buttonhole
Depending on your preference, you may adjust stitch
density within the green zone on the stitch length control.
*
For more density, turn the stitch length control
toward "0".
Fine stitches for lightweight fabrics.
*
For less density, turn the stitch length control
toward "1".
Coerse stitches for heavyweight fabrics.
NOTE: Always check a buttonhole on a scrap of fabric to
make sure the adjustment satisfies you.
6
7
1
Stitch selector:
BH
Presser foot:
Sliding buttonhole foot
Thread tension:
1 - 5
Stitch length:
(0.5 - 1)
4
1
2
3
0
1
2
3
4
4
1
2
3
BH
1
4
2
3
0
1
C
A
B
D
E
F
G
1
4
2
3
H
1
2
(A)
(B)
(C)
1
4
2
3
4
2
Janome US2014 Instruction Manual
www.aaasewing.com
US2014 Owners Manual/ User Guide
