www.toews.com
50
r
q
w
e
Button Sewing
Unthread the needle thread.
Adjust the stitch width so that the needle enters
both holes in the button.
Place a button on the fabric and lower the needle
by turning the handwheel, so that the needle
enters into the left hole in the button.
Align the holes in the button with the slot on the
foot and lower it to hold the button in place.
Turn the handwheel to lower the needle into the
right hole in the button.
Adjust the stitch width if necessary.
Rethread the machine and sew about 10 stitches
at a slow speed (set the speed control slider at ).
Raise the presser foot and remove the fabric.
Trim both needle and bobbin threads at the
beginning.
Cut both threads leaving 20 cm (8”) tails.
Pull the bobbin thread to bring the needle thread to
the wrong side of the fabric then knot the threads.
After sewing is finished, raise the feed dog.
Machine Settings
q
Pattern:
#08
w
Presser foot:
Satin stitch foot F
e
Threaad tension:
3-7
r
Feed dog:
Down
Janome 4030QDC Instruction Manual
Janome Sewing Machine 4030QDC
www.toews.com
4030QDC Owners Manual/ User Guide
