10
TO ADJUST THE PRESSER BAR HEIGHT
Correct Setting:
The distance between the surface of needle plate and bottom of presser foot should be 4.7 to 5.3 mm (47/254
to 53/254”) when the presser bar lifter is raised.
To adjust:
1. Remove the face plate unit.
2. Remove the setscrew A to move the lamp socket unit.
3. Raise the presser bar lifter, and loosen the setscrew B.
Then adjust the presser bar height, the side of presser foot should be parallel with the hole of needle plate.
4. Tighten the setscrew B.
5. Tighten the setscrew A.
6. Attach the face plate unit.
Presser bar lifter
To be parallel
4.7 ~ 5.3 mm
(Direction of presser foot)
Setscrew B
Setscrew A
(3 pcs)
Top surface of needle plate
Lamp socket unit
Summary of Contents for 1110DX PRO
Page 1: ...SERVICE MANUAL 1110DX PRO...
