JANE KIDS ZONE SMART, Manual

Page: 6 / 23

6
EN
ASSEMBLING THE PORTABLE CARRYCOT
1 Use the zips to attach the plastic reinforcements around the perimeter of your
SMART carrycot.
ATTENTION: This step should never be performed with the baby inside the carrycot.
Risks from sharp edges and getting fingers and other body parts caught or squeezed by
the carrycot are inevitable during this step.
ATTACH TO THE PUSHCHAIR
2 Remove the safety bar, position the pushchair’s backrest and footrest
horizontally and always activate the brake before attaching or removing your
SMART carrycot.
3 Position your SMART carrycot so that your baby’s head is on the opposite side of
the handlebar.
4 Adjust the cot (E) to position your baby’s head at the right angle.
5 SMART is equipped with adjustable straps (D) so that you can attach the carrycot
to your pushchair.
First, position the straps on each side of your pushchair by inserting the buckle
through the strap ring as shown in illustration 5a and then buckle in the carrycot
using the strap previously installed on your stroller 5b.
Lastly, pass the straps found under the carrycot through the slits in the pushchair
belts and fasten them 5c.
Adjust the length of the strap with the buckle if necessary 5d.
CAREFUL! Before use, make sure that the buckles on both sides are securely anchored
and that the carrycot is securely fastened to the pushchair.
IMPORTANT- Read these instructions carefully before use
and keep them for future reference
1
2
3
4
5
a
5
b
5
d
5
c