JANE CONCORD iTOURER, Instructions Manual

Page: 41 / 102

39
EN
_ Installing the safety seat in the car
• Pull the two ISOFIX anchors (5) fully out by pressing the buttons on each anchor (5a) and
sliding them out. ( 1c )
• In some cars, the ISOFIX anchors are difficult to access or are hidden between the vehicle
seat foam. Guides (19) are supplied with the safety seat to make it easier to locate the
anchor points, insert them before the next step.
• Guide the anchors towards the axles in your car and press until both sides both sides are
locked, two green signals displayed on both buttons (5b) or two green lights on the control
panel (6) will indicate that they are locked. If one or both the signals are red, try again. ( 1d )
• Press the base (3) against the backrest of the vehicle seat until it is held firmly in place. ( 1e )
• Release the leg height lock by pressing the buttons (4b). Extend the leg until it touches the
floor of the vehicle. Lift the safety seat until the buttons (4b) lock again, the green signal will
be displayed on the base of the leg (4c) or on the control panel (6). ( 1f )